ProStart CT-3371 Installationsanleitung PDF herunterladen (Seite 22)

P.22 Installation guide

• to lock the doors and shut down the engine;

• to unlock the doors and shut down the engine;

• to shut down the engine without affecting the doors.

7. The Parking light will flash twice to confirm ready mode activation.

HornTimingAdjustment

Follow these steps to adjust horn pulse timing:

1. Enter programming mode (page-17) - the parking lights will stay on for up to 20

seconds.

2. Press and hold the brake pedal, then simultaneously press the

and buttons ⎯

the horn will chirp 5 times.

3. Release the brake pedal.

4. To change the timing:

a. To increase the Horn pulse by 3 ms, press the

button.

b. To decrease the pulse by 3 ms, press the

button.

c. To increase the pulse by 10 ms, press the button.

d. To decrease the pulse by 10 ms, press the

button.

5. To save the new settings: press

and . The horn will honk three times to indicate

that the settings have been successfully saved.

Arminganddisarmingthestarterkill

This added security feature will prevent the vehicle from starting with the Ignition key when the

starter kill is armed. If the system was installed with the starter kill option, you will not be able to

start the vehicle with the key unless the system has been unlocked first or put into Valet Mode.

Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter

motor damage that could occur after remote-starting the engine should the user, by force of

habit, turn the ignition key to the CRANK position.

The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm

automatically) or Active Mode (so as to require the user’s intervention for arming). By default, the

Remote Car Starter is configured to Passive Mode.

Passive mode:

To arm the Starter Kill, press the

button on the transmitter, OR

1. In Passive Mode, the Starter Kill will also arm automatically 1 minute (by default) or 3

minutes (if configured this way) after the ignition is turned OFF or once the last door is

closed (if the doors are monitored).

2. The LED on the antenna will remain OFF during the countdown preceding the activation

of the Starter Kill.

3. Once the activation countdown expires, the LED will flash slowly to indicate that the

Starter Kill is now armed.

To disarm the Starter Kill, press the

button on the transmitter.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare

ProStart CT-3371 Installationsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedingungen ProStart CT-3371